2008 Chevrolet Silverado
Mileage
170,329
Service Date
5/19/2021
Services Performed
- Inspected and found leak from aftermarket fill tube adapter. Siliconed and replaced hose clamps.
- Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
- Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
- Removed all lines and sending unit plug from fuel tank. Removed fuel tank mounting straps to allow tank to be removed. Drained and saved fuel from tank. Removed sending unit from vehicle to gain access to fuel level sensor. Removed fuel level sensor and cleaned all debris from tank. Installed new fuel level sensor. Re installed tank and all removed parts. Re installed fuel and road tested. Checked for leaks.
- Removed and replaced transfer case output shaft seal. Cleaned area and road tested. Verified no leaks.
- Removed chip monitor from dash. Pulled wiring through firewall and removed wires and module from engine bay.
- Removed passenger side fender well from vehicle to access block heater and heater cord. Remove and replace block heater with new heater coil. Refilled coolant system and tested for leaks. Re installed all removed parts.
- Removed rear driveline, removed center support bearing. Pressed u joint from driveline and installed new u joint. Installed new center support bearing and re installed driveline.
- Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Install power steering additive to revitalize seals and road test vehicle.
Jason R. gave our service a 5 star review on 5/22/2021
