Call (541) 317-3589

Chevrolet

/Chevrolet

We Service and Repair All Chevrolet Cars

2006 Chevrolet Silverado

2022-08-25T22:00:07+00:00

Chevrolet Silverado

Mileage
187,353
Service Date
8/23/2022
Services Performed
  • Removed all parts necessary to access glow plugs. Removed and replaced all glow plugs. Re installed all removed parts and road tested.
  • Wired in aftermarket accent headlight lighting. Wired lights directly to parking light. Tested functions.
 
Don D. gave our service a 5 star review on 8/24/2022
2006 Chevrolet Silverado 2022-08-25T22:00:07+00:00

2006 Chevrolet Silverado

2022-06-25T22:59:05+00:00

Chevrolet Silverado

Mileage
175,320
Service Date
6/23/2022
Services Performed
  • FUEL INJECTOR – Remove & Replace – Diesel Both Sides,All Eight
  • FUEL INJECTION PUMP – Remove & Replace – Diesel,Automatic Trans
  • Unplug water in fuel sensor and remove existing fuel filter from vehicle. Transfer water in fuel sensor to the new filter and install in vehicle. Prime the system and restart vehicle checking for leaks
  • POWER BRAKE BOOSTER – Remove & Replace – Hydraulic – [Includes: Bleed Power Steering System.]
  • POWER STEERING HOSE – Remove & Replace – Pressure,w/Hydraulic Brake Booster,Both – [Includes: R&I Fender Liner.] – [Includes: Bleed System.]
  • Remove the Charge air tubes, boots and clamps. Clean all components and reinstall all.
  • Recenter down pipe clamp and tighten
  • WHEEL HUB – Remove & Replace – 2500 HD,4WD Front,Both
  • Left front axle seal leaks: Clean & watch
 
Steve J. gave our service a 5 star review on 6/24/2022
2006 Chevrolet Silverado 2022-06-25T22:59:05+00:00

2005 Chevrolet Silverado

2022-06-19T22:01:56+00:00

Chevrolet Silverado

Mileage
175,516
Service Date
6/17/2022
Services Performed
  • Removed rear tires, brake pads, calipers, and rotors. Inspected for parking brake contamination, none. Removed and replaced both wheel seals. Re installed all removed parts. Road tested.
  • Removed and replaced side step bars.
 
Marc F. gave our service a 5 star review on 6/17/2022
2005 Chevrolet Silverado 2022-06-19T22:01:56+00:00

2006 Chevrolet Silverado

2022-06-03T21:59:43+00:00

Chevrolet Silverado

Mileage
185,721
Service Date
6/1/2022
Services Performed
  • Removed bumper and grilled to access transmission cooler lines. Removed and replaced all transmission oil cooler lines. Re installed bumper and grille with new, client supplied, head lamp assemblies. Added fluid to recommended levels.
  • Removed and replaced client supplied tail light assembly.
  • Power steering hose – Remove & Replace –
  • Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Install power steering additive to revitalize seals and road test vehicle.
  • Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
 
Don D. gave our service a 5 star review on 6/2/2022
2006 Chevrolet Silverado 2022-06-03T21:59:43+00:00

2021 Chevrolet Silverado 3500 HD

2022-02-09T23:03:35+00:00

Chevrolet Silverado 3500 HD

Mileage
15,556
Service Date
2/8/2022
Services Performed
  • Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Found air filter dirty, removed and replaced. Cabin air filter due for replacement via mileage. Inspected and found cabin air filter plugged/ dirty, removed and replaced. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
  • Drain fuel filter by tank, remove cartridge and clean housing. Install new cartridge and reassemble. Perform bleed procedure and reset maintenance minder
 
Curtis B. gave our service a 5 star review on 2/8/2022
2021 Chevrolet Silverado 3500 HD 2022-02-09T23:03:35+00:00

2006 Chevrolet Silverado

2021-11-18T23:03:43+00:00

Chevrolet Silverado

Mileage
235,077
Service Date
11/17/2021
Services Performed
  • Diesel electronic engine control system performance tests: Check for stored fault codes. Monitor data stream parameters. Check fuel supply and delivery systems. Check glow plug/intake heater system as equipped. Perform pinpoint tests for listed fault codes. Inspected and found coolant leak from flywheel cover plate on housing, recommend replacing gasket. Client reported overheating and coolant loss. Last thermostats, water pump, radiator, coolant flush?
  • Diesel electronic engine control system performance tests: Check for stored fault codes. Monitor data stream parameters. Check fuel supply and delivery systems. Check glow plug/intake heater system as equipped. Perform pinpoint tests for listed fault codes. Codes: P0401 EGR flow insufficient, P0087 fuel rail pressure too low. Injector rates 1) -1.48, 2)2.8, 3) 4.89, 4)-1.61, 5) 0.73, 6) -1.33, 7)-1.61, 8) -1.
  • Drained motor oil, coolant and refrigerant. Removed inner fender wells, CAC tubes & boots, air box & inlet hose, front grill, bumper, transmission cooler lines, fan shroud & fan, serpentine belt, radiator hoses, radiator and cleaned area's. Removed heater hoses, fuse box & wire/ connectors, steering shaft, master cylinder and all lines to booster. Removed and replaced hydroboost. Unbolted nerf step/ bars, cab bolts, disconnected wiring, unclipped parking brake cable and transmission shift cable. Unbolted cab mounts and lifted cab. Unbolted exhaust and removed turbo, removed right side parts to injectors. Removed all parts on front of motor to high pressure fuel pump. Removed all parts on left to injectors. Cleaned motor valley and all parts. Removed cover plate and gasket due to coolant leak on right rear of adapter plate. Installed new high pressure fuel pump with mounting plate. Removed and replaced fuel return lines. Removed and replaced intake gaskets with new o rings. Removed and replaced water pump with gasket/ o ring. Removed and replaced thermostats. Removed and replaced idler pulleys, serpentine belt tension, alternator and water pump bypass hose with new clamps. Removed all injectors, cleaned area and installed new injectors. Installed new injector fuel return lines. Re installed all removed parts on left, right and center with new gaskets/ o rings/ clamps as needed. Removed and replaced turbo coolant hose. Installed new turbo with install kit. Removed and replaced all power steering lines. Fuel filter was not original, Installed OE style filter and new water sensor. Installed new upper and lower radiator hose. Installed new degas cap and serpentine belt. Tested all glow plugs, passed. Removed and replaced failed transmission cooler line clip. Re installed all removed parts and cab. Charged A/C. Installed motor oil with new filter and coolant. (see oil cooler line). Reprogrammed PCM injectors numbers then reprogrammed GPC injector numbers. Bled air out of power steering system with new fluid. Performed turbo learn procedures, passed. Road tested and verified no leaks.
  • WATER PUMP – Remove & Replace – Additional time during cab pull, normal billable hours 6.1
  • THERMOSTAT – Remove & Replace -Additional time during cab pull, normal billable hours 2.0
  • RADIATOR – Remove & Replace […]
2006 Chevrolet Silverado 2021-11-18T23:03:43+00:00

2004 Chevrolet Silverado

2021-11-11T23:03:29+00:00

Chevrolet Silverado

Mileage
182,018
Service Date
11/10/2021
Services Performed
  • Low on fuel
  • Play in steering gear box shaft, idler & pitman arm. See list of recommendations. Unable to fully road test due to low fuel.
 
Tyler F. gave our service a 5 star review on 11/10/2021
2004 Chevrolet Silverado 2021-11-11T23:03:29+00:00

2006 Chevrolet Silverado

2021-11-11T23:02:19+00:00

Chevrolet Silverado

Mileage
129,425
Service Date
11/9/2021
Services Performed
  • Checked for codes, none found. Unable to duplicate concern. All 4wd functions normal at this time.
  • Drain transfer case and inspect for debris, refill with new fluid. Check linkage adjustment and for proper transfer case operation.
  • Inspected and found transfer case rear output seal has moderate leak. Removed rear driveline to access seal. Removed and replaced rear output seal. Re installed driveline and road tested. Verified no leaks.
  • Removed PTO covers, cleaned all surfaces. Installed new gaskets and resealed PTO covers. Road tested and verified no leaks.
  • Drain fluid and remove pan. Inspect for debris and clean pan. Change internal filter and reinstall pan. Change external filter. Refill unit with new fluid. Road test and check for leaks.
  • Removed all parts necessary to access arms. Removed and replaced Idler and Pitman arm. Re installed all removed parts. Road tested.
  • Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
  • Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
  • Removed all parts necessary to access hydroboost. Removed and replaced hydroboost. Re installed all removed parts. Added fluids to recommended levels. Road tested and verified no leaks.
  • Suction out reservoir and install flushing equipment loaded with new fluid. Install suction on each caliper and recover old fluid. Clean area when finished.
  • Removed and replaced both failed third brake light bulbs.
  • Inspected and found both high pressure hoses leaking. Removed and replaced both high pressure power steering hoses. Cleaned area. Road tested and verified no leaks.
  • Inspected client supplied seat cover. Found cover does not have correct cut outs for power seat controls.
  • Removed and replaced both rear shocks with client supplied shocks. Found 1 client supplied front shock missing upper bushing kit. Installed 1 client supplied front shock. Installed 1 shop supplied front shock on left front. Placed client supplied shock w/ missing bushing kit back into truck for client to return.
  • Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
  • Unplug water in fuel sensor and remove existing fuel filter from vehicle. Transfer water in fuel sensor to the new filter and install in vehicle. Prime the system and restart vehicle checking for leaks
 
Ed C. gave our service a 5 star review on 11/10/2021
2006 Chevrolet Silverado 2021-11-11T23:02:19+00:00

2008 Chevrolet Silverado

2021-08-19T22:00:59+00:00

Chevrolet Silverado

Mileage
174,168
Service Date
8/17/2021
Services Performed
  • Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Replaced missing retainer clips on right front fenderwell. Removed and replaced air filter. Cleaned mas air flow sensor. Tire monitor light on in dash. Reset maintenance reminder if applicable.
 
Jason R. gave our service a 5 star review on 8/19/2021
2008 Chevrolet Silverado 2021-08-19T22:00:59+00:00

2007 Chevrolet Silverado

2021-07-29T22:04:43+00:00

Chevrolet Silverado

Mileage
41,013
Service Date
7/28/2021
Services Performed
  • Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Install power steering additive to revitalize seals and road test vehicle.
  • Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
  • Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket. Install new fluid to proper level. Road test vehicle for proper operation.
  • Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
  • Drain transfer case and inspect for debris, refill with new fluid. Check linkage adjustment and for proper transfer case operation.
  • Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
  • Renew fuel filter and transfer sensor. Bleed system and check for leaks
 
Mark E. gave our service a 5 star review on 7/28/2021
2007 Chevrolet Silverado 2021-07-29T22:04:43+00:00