Ford Archives - Inter Mountain Truck & Auto Repair

2019 Ford F-350 Super Duty
Mileage
118,809
Service Date
7/29/2026
Services Performed
Diesel electronic engine control system performance tests: Check for stored fault codes. Monitor data stream parameters. Perform pinpoint tests for listed fault codes. Inspection P0170 and P0402, Watched operation of egr valve on scan tool. Valve would stick and jump when actuated. Recommend replacement of EGR valve.
Removed components to access the EGR valve. Removed the existing EGR valve and inspected for debris. Installed new EGR valve and gaskets. Top off cooolant, clear codes and test drive to confirm proper operation.
Removed the upper intake in order to access the broken bolts from EGR tube to exhaust manifold. Drilled, tapped and helicoiled the area and reassembled all.
Dan R. gave our service a 5 star review on 7/29/2026
2004 Ford Pickup
Mileage
262,184
Service Date
6/17/2026
Services Performed
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation
Lynn C. gave our service a 5 star review on 6/17/2026
2004 Ford Pickup
Mileage
262,184
Service Date
6/17/2026
Services Performed
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation
Lynn C. gave our service a 5 star review on 6/17/2026
2012 Ford Pickup
Mileage
70,760
Service Date
5/6/2026
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling system. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation
Replace both batteries. Clean battery tray. Clean cables and apply corrosion inhibitor to terminals.
Hadley M. gave our service a 5 star review on 5/6/2026
2019 Ford F-350 Super Duty
Mileage
101,179
Service Date
3/24/2026
Services Performed
FRONT SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
REAR SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
Lynn S. gave our service a 5 star review on 4/9/2026
2019 Ford F-350 Super Duty
Mileage
101,016
Service Date
3/9/2026
Services Performed
Check for codes & print diagnostics sheet for updates if applicable
Vehicle Condition Inspection: Visually inspect steering and suspension systems. Inspect exhaust system. Check belts and hoses. Check all fluid levels and condition. Check all external lighting. Check charging and starting systems. Check brakes at all 4 wheels. Check for fault codes. Check for service bulletins and recall notices. Road test vehicle. Check for services due for mileage interval. Consult with customer on recommended services/repairs.
Lynn S. gave our service a 5 star review on 3/10/2026
2020 Ford F-350 Super Duty
Mileage
45,583
Service Date
1/28/2026
Services Performed
Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket or resealed cover. Install new fluid to proper level. Road test vehicle for proper operation.
Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gasket or resealed cover. Install new fluid to proper level. Road test vehicle for proper operation.
Drain transfer case and inspect for debris, refill with new fluid. Tested all operations.
removed the existing drag link and tie rod ends. Install new components and lube same. Road test after alignment to confirm proper operation
Alignment reset after component replacement Inv 31303
Removed the front trac bar and pressed the old bushing out and installed a new bushing.
On removal of the trac bar from the front of the truck, excess wear was noted on the ball joint. Existing ball joint pressed out and new joint pressed in. Trac bar then reinstalled in truck
Removed the existing oil separator ( CCV filter ), cleaned affected area and installed a new separator. Check for leak free operation
Mike W. gave our service a 5 star review on 2/13/2026
2016 Ford F-350 Super Duty
Mileage
81,622
Service Date
2/4/2026
Services Performed
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation. Please note that the lower cap at the frame rail mounted filter was replaced due to damage to the cap.
Removed and resealed vacuum pump. While vacuum pump was removed belt, pulleys and tensioners were evaluated. It was noted that belt and pulleys were due for replacement. Belt, tensioner and idler pulley replaced at this time.
Removed the torn air deflector and installed a new factory replacement
Vince B. gave our service a 5 star review on 2/4/2026
2013 Ford F-250 Super Duty
Mileage
114,544
Service Date
10/15/2025
Services Performed
Inspection found codes P207F ( 00-06C & 00-EC ) for reductant quality performance. Truck in reduced speed mode due to Emissions fault. Conducted DEF dosing test and DEF quality test. Dosing past at 50ml consistent, but the quality test failed. Dropped the DEF pump and tank assembly. Drained and flushed out the existing DEF fluid. Refilled the system and bled the air form the lines. Cleared codes and test drove. Upon completion of test drive performed a static regen and confirmed system is now working as designed.
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling system. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Air filter replaced this visit
Initial inspection found upper radiator hose pulled flat. Tested radiator cap and found it would hold up to 30PSI before releasing. Installed new radiator cap this visit.
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation
Jack B. gave our service a 5 star review on 10/16/2025
2008 Ford Econoline
Mileage
100,767
Service Date
10/9/2025
Services Performed
Vehicle Condition Inspection: Visually inspect steering and suspension systems. Inspect exhaust system. Check belts and hoses. Check all fluid levels and condition. Check all external lighting. Check charging and starting systems. Check brakes at all 4 wheels. Check for fault codes. Check for service bulletins and recall notices. Road test vehicle. Check for services due for mileage interval. Consult with customer on recommended services/repairs.
Removed right side dash panel to remove dog house and verified EGR cooler is in place. Reinstalled removed components. Road tested to operational temperatures to open thermostat. Performed coolant reservoir/ block test for combustion, passed. Verified no water/ coolant in oil. Noted oil is low on dipstick. Coolant reservoir cap bleeds off pressure. No concerns found.
Mike O. gave our service a 5 star review on 10/9/2025

Ford

We Service and Repair all Ford cars