Chevrolet Archives - Page 2 of 4 - Inter Mountain Truck & Auto Repair

2008 Chevrolet TrailBlazer
Mileage
172,181
Service Date
1/9/2023
Services Performed
Inspected and found the axle disconnect on passengers side of pan and CV shaft are both shattered. No noise from rear.
Differential lock actuator – Remove & Replace –
Removed tire, loosened upper ball joint and disconnected brake line bracket from knuckle. Removed axle shaft and 4wd actuator, found actuator split in half required drilling/ tapping for removal. Installed new 4wd actuator and axle shaft. Re installed all removed parts. Road tested & verified 4wd operations.
Sublet Credit
Rob I. gave our service a 5 star review on 1/9/2023
2011 Chevrolet Silverado
Mileage
73,371
Service Date
10/21/2022
Services Performed
Greased and inspected for steering concerns. Found both pitman arm and idler arm are popping with movement. Recommend replacing idler arm and pitman arm with front end alignment.
Vehicle Condition Inspection: Visually inspect steering and suspension systems. Inspect exhaust system. Check belts and hoses. Check all fluid levels and condition. Check all external lighting. Check charging and starting systems. Check brakes at all 4 wheels. Check for fault codes. Check for service bullitens and recall notices. Road test vehicle. Check for services due for mileage interval. Consult with customer on recomended services/repairs.
Blaine C. gave our service a 5 star review on 10/22/2022
2006 Chevrolet Silverado
Mileage
240,244
Service Date
10/5/2022
Services Performed
Upon testing unit, Code C0327 Encoder circuit malfunction was present.
Removed the existing encoder motor and installed a replacement GM motor. Re attach all components and test for proper operation.
Rob B. gave our service a 5 star review on 10/5/2022
2004 Chevrolet Silverado
Mileage
80,668
Service Date
9/27/2022
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling system. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Removed and replaced failed fuel cap.
Bryce B. gave our service a 5 star review on 9/27/2022
2006 Chevrolet Silverado
Mileage
187,353
Service Date
8/23/2022
Services Performed
Removed all parts necessary to access glow plugs. Removed and replaced all glow plugs. Re installed all removed parts and road tested.
Wired in aftermarket accent headlight lighting. Wired lights directly to parking light. Tested functions.
Don D. gave our service a 5 star review on 8/24/2022
2006 Chevrolet Silverado
Mileage
175,320
Service Date
6/23/2022
Services Performed
FUEL INJECTOR – Remove & Replace – Diesel Both Sides,All Eight
FUEL INJECTION PUMP – Remove & Replace – Diesel,Automatic Trans
Unplug water in fuel sensor and remove existing fuel filter from vehicle. Transfer water in fuel sensor to the new filter and install in vehicle. Prime the system and restart vehicle checking for leaks
POWER BRAKE BOOSTER – Remove & Replace – Hydraulic – [Includes: Bleed Power Steering System.]
POWER STEERING HOSE – Remove & Replace – Pressure,w/Hydraulic Brake Booster,Both – [Includes: R&I Fender Liner.] – [Includes: Bleed System.]
Remove the Charge air tubes, boots and clamps. Clean all components and reinstall all.
Recenter down pipe clamp and tighten
WHEEL HUB – Remove & Replace – 2500 HD,4WD Front,Both
Left front axle seal leaks: Clean & watch
Steve J. gave our service a 5 star review on 6/24/2022
2005 Chevrolet Silverado
Mileage
175,516
Service Date
6/17/2022
Services Performed
Removed rear tires, brake pads, calipers, and rotors. Inspected for parking brake contamination, none. Removed and replaced both wheel seals. Re installed all removed parts. Road tested.
Removed and replaced side step bars.
Marc F. gave our service a 5 star review on 6/17/2022
2006 Chevrolet Silverado
Mileage
185,721
Service Date
6/1/2022
Services Performed
Removed bumper and grilled to access transmission cooler lines. Removed and replaced all transmission oil cooler lines. Re installed bumper and grille with new, client supplied, head lamp assemblies. Added fluid to recommended levels.
Removed and replaced client supplied tail light assembly.
Power steering hose – Remove & Replace –
Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Install power steering additive to revitalize seals and road test vehicle.
Install coolant flushing equipment. Flush and recover old coolant from system. Refill system with new coolant to proper freeze/boil protection. Check for proper thermostat operation. Road test vehicle.
Don D. gave our service a 5 star review on 6/2/2022
2021 Chevrolet Silverado 3500 HD
Mileage
15,556
Service Date
2/8/2022
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Found air filter dirty, removed and replaced. Cabin air filter due for replacement via mileage. Inspected and found cabin air filter plugged/ dirty, removed and replaced. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Drain fuel filter by tank, remove cartridge and clean housing. Install new cartridge and reassemble. Perform bleed procedure and reset maintenance minder
Curtis B. gave our service a 5 star review on 2/8/2022
2006 Chevrolet Silverado
Mileage
235,077
Service Date
11/17/2021
Services Performed
Diesel electronic engine control system performance tests: Check for stored fault codes. Monitor data stream parameters. Check fuel supply and delivery systems. Check glow plug/intake heater system as equipped. Perform pinpoint tests for listed fault codes. Inspected and found coolant leak from flywheel cover plate on housing, recommend replacing gasket. Client reported overheating and coolant loss. Last thermostats, water pump, radiator, coolant flush?
Diesel electronic engine control system performance tests: Check for stored fault codes. Monitor data stream parameters. Check fuel supply and delivery systems. Check glow plug/intake heater system as equipped. Perform pinpoint tests for listed fault codes. Codes: P0401 EGR flow insufficient, P0087 fuel rail pressure too low. Injector rates 1) -1.48, 2)2.8, 3) 4.89, 4)-1.61, 5) 0.73, 6) -1.33, 7)-1.61, 8) -1.
Drained motor oil, coolant and refrigerant. Removed inner fender wells, CAC tubes & boots, air box & inlet hose, front grill, bumper, transmission cooler lines, fan shroud & fan, serpentine belt, radiator hoses, radiator and cleaned area's. Removed heater hoses, fuse box & wire/ connectors, steering shaft, master cylinder and all lines to booster. Removed and replaced hydroboost. Unbolted nerf step/ bars, cab bolts, disconnected wiring, unclipped parking brake cable and transmission shift cable. Unbolted cab mounts and lifted cab. Unbolted exhaust and removed turbo, removed right side parts to injectors. Removed all parts on front of motor to high pressure fuel pump. Removed all parts on left to injectors. Cleaned motor valley and all parts. Removed cover plate and gasket due to coolant leak on right rear of adapter plate. Installed new high pressure fuel pump with mounting plate. Removed and replaced fuel return lines. Removed and replaced intake gaskets with new o rings. Removed and replaced water pump with gasket/ o ring. Removed and replaced thermostats. Removed and replaced idler pulleys, serpentine belt tension, alternator and water pump bypass hose with new clamps. Removed all injectors, cleaned area and installed new injectors. Installed new injector fuel return lines. Re installed all removed parts on left, right and center with new gaskets/ o rings/ clamps as needed. Removed and replaced turbo coolant hose. Installed new turbo with install kit. Removed and replaced all power steering lines. Fuel filter was not original, Installed OE style filter and new water sensor. Installed new upper and lower radiator hose. Installed new degas cap and serpentine belt. Tested all glow plugs, passed. Removed and replaced failed transmission cooler line clip. Re installed all removed parts and cab. Charged A/C. Installed motor oil with new filter and coolant. (see oil cooler line). Reprogrammed PCM injectors numbers then reprogrammed GPC injector numbers. Bled air out of power steering system with new fluid. Performed turbo learn procedures, passed. Road tested and verified no leaks.
WATER PUMP – Remove & Replace – Additional time during cab pull, normal billable hours 6.1
THERMOSTAT – Remove & Replace -Additional time during cab pull, normal billable hours 2.0
RADIATOR – Remove & Replace -Additional time during cab pull, normal billable hours 2.0
FUEL INJECTION PUMP – Remove & Replace – Additional time during cab pull, normal billable hours 12.0
Removed all parts needed to access fuel injectors. Removed fuel injectors/ CP3 pump. Sent all for testing. Re installed CP3 pump and replaced all injectors. Re installed all parts with new fuel filter. Road tested, checked for codes, checked for leaks.
Alternator – Remove & Replace Additional time during cab pull, normal billable hours 1.4
Replace both batteries and battery bolts. Clean battery tray. Clean cables and apply corrosion inhibitor to terminals. Repaired washer fluid line behind driver side battery.
Found coolant leaking after adding fluids. Inspected and found left side of adapter plate, between motor & transmission to oil
Rob B. gave our service a 5 star review on 11/17/2021

Chevrolet

We Service and Repair all Chevrolet cars