CRM Mitchell1, Author at Inter Mountain Truck & Auto Repair

2021 Chevrolet Silverado 3500 HD
Mileage
47,777
Service Date
7/29/2024
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Drain fuel filter by tank, remove cartridge and clean housing. Install new cartridge and reassemble. Perform bleed procedure and reset maintenance minder
Curtis B. gave our service a 5 star review on 7/29/2024
2006 Dodge Pickup
Mileage
130,015
Service Date
7/18/2024
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Serviced re usable air filter. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check external lighting. Reset maintenance reminder if applicable. Found aftermarket lights wiring in plastic bags, bags are full of water and causing damage to wiring, placed drain holes in bags.
Inspected rear drive line rear u joint. Inspected and found u joint rusted, applied grease, recommend replacing u joint with non greasable u joint instead of adjusting for grease zerk.
Unbolted fan shroud and removed serpentine belt. Removed and replaced failed tensioner. Installed new belt due to old belt missing rib. Reinstalled all removed parts and road tested.
Philip C. gave our service a 5 star review on 7/19/2024
2007 GMC Sierra Classic
Mileage
69,051
Service Date
6/11/2024
Services Performed
Vehicle Condition Inspection: Visually inspect steering and suspension systems. Inspect exhaust system. Check belts and hoses. Check all fluid levels and condition. Check all external lighting. Check charging and starting systems. Check brakes at all 4 wheels. Check for fault codes. Check for service bullitens and recall notices. Road test vehicle. Check for services due for mileage interval. Consult with customer on recomended services/repairs.
Removed batteries and charged.
Suctioned fuel out of tank at fill neck. Disconnected hard line from top of tank and drained fuel in lines. Added howes fuel treatment and added client supplied 10 gallons plus shop supplied 10 gallons.
Removed right front inner fender liner, drained and removed fuel filter. Transfer WIF sensor to new fuel filter, installed filter and cleaned area. Reinstalled fender liner and primed filter. Road tested.
Mike K. gave our service a 5 star review on 6/14/2024
2005 Ford Pickup
Mileage
131,622
Service Date
5/14/2024
Services Performed
Drain water from water separator, remove secondary fuel filter and install new filter. Remove primary fuel filter, clean bowl and install new fuel filter. Purge air from fuel system and start vehicle. Inspect for proper operation
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling system. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check all exterior lighting. Reset maintenance reminder if applicable.
Keith P. gave our service a 5 star review on 5/14/2024
2017 Ford F-150
Mileage
102,976
Service Date
4/29/2024
Services Performed
Pulled vehicle into shop, confirmed steering stiffness, noted ABS light on and stabilitrac message warning. Checked codes: U0415 invalid data received from antilock brake system control moduleA, C0030 left front tone wheel, C0051 steering wheel position sensor. Inspected and found left front wheel bearing has severe play. Both front tires have notable uneven wear on inside. Removed left front tire and found even pad wear (8mm), uneven rotor wear. Recommend replacing both front wheel bearings, 4wd hubs, front brakes and tire rotation.
Removed damaged unit bearings, Integrated wheel ends and brake components. Installed new IWE's and Unit Bearings, Cleaned brake calipers / slides and installed new pads and rotors upon re – assembly. Road test to bed in the brakes and confirm proper operation
Rotate all 4 tires per manufactuer recommendation. Inspect for wear and set air pressures.
Kassidy K. gave our service a 5 star review on 4/29/2024
2016 RAM 2500 HD
Mileage
205,302
Service Date
4/9/2024
Services Performed
Change engine oil and filter. Lube chassis. Visually inspect steering, suspension, exhaust, brakes and cooling systems. Check all fluid levels and add as necessary. Inspect condition of drive belts and hoses. Check external lighting. Reset maintenance reminder if applicable.
Jason R. gave our service a 5 star review on 4/10/2024
2004 Dodge Pickup
Mileage
144,250
Service Date
2/26/2024
Services Performed
Client would like all belts changed. Hoses are OE, check and replace if needed. – Look over
Removed right front inner gender well, unbolted and removed air box, horn tube to turbo, and inner fan shroud. Cut out failed serpentine belt from around fan clutch. Unbolted tensioner and removed with the remainder of the serpentine belt. Noted the A/C compressor is leaking from behind clutch and fan clutch is leaking. Recommend replacing fan clutch and A/C system. Completed recommended repairs and installed new belt tensioner assembly with serpentine belt. Road tested.
Removed and replaced fan clutch.
Evacuate and recover refrigerant from A/C system. Renew A/C compressor, receiver/dryer & orifice tube. Unbolted battery cables and removed right side battery tray. Flush lines, condenser and evaporator core. Install A/C equipment and pull vacuum on system and check for leaks. Cleaned all battery cables and batteries. Reinstalled all removed parts. Recharge system to capacity. Check for proper system operation and check outlet temperatures.
Removed and replaced A/C condenser.
Isaiah S. gave our service a 5 star review on 2/26/2024
2005 Dodge Pickup
Mileage
213,836
Service Date
2/15/2024
Services Performed
Inspected key, excessively worn. Installed key in ignition start and stopped motor with key multiple times with no concerns. Found that key will pull out in any position while motor is running. Checked and cleared codes. Removed and replaced ignition lock cylinder, set to match current key/ lock. Tested key with and without motor running.
Ignition lock cylinder – Remove & Replace –
Inv # 296275
Rick H. gave our service a 5 star review on 2/19/2024
2017 RAM 3500 HD
Mileage
121,093
Service Date
11/21/2023
Services Performed
Road tested and inspected. Found right front wheel hub/ unit bearing has excessive movement. recommend replacing both wheel hub/ unit bearings.
Removed front tires and brakes. Removed wheel hubs, cleaned spindles and installed new wheel hubs. Reinstalled all removed parts and road tested.
Removed rear tires, calipers, hub, rotors. Found rear wheel seals leaking, removed and replaced rear wheel seals. Cleaned all parts and installed new rotors, pads and calipers. Reinstalled all removed parts. Completed brake fluid flush and bled air from system. Road tested.
Suction out reservoir and install flushing equipment loaded with new fluid. Install suction on each caliper and recover old fluid. Clean area when finished.
Removed all parts necessary and removed serpentine belt. Inspected tensioner and pulley. Installed new serpentine belt and re installed all removed parts. Road tested.
DEF fluid: top off
Removed and replaced front shocks
Removed and replaced rear shocks.
Kerry F. gave our service a 5 star review on 11/23/2023
2004 Ford Pickup
Mileage
248,996
Service Date
11/13/2023
Services Performed
Removed headlight assembly. Installed new headlight assembly and all bulbs. Adjusted as needed.
Lynn C. gave our service a 5 star review on 11/15/2023

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars